N$14), and replace it with "GND" (sans the quotation marks). Start by naming the net connected to the top, GND pin. With the NAME tool selected, clicking on a net should open a new dialog. Next, we'll use the NAME tool - (left toolbar, or under the Edit menu) - to name each of the six nets. Place your microcontroller in the center of the frame, then add the other parts around it like so: To rotate parts as your placing them, either select one of the four options on the rotate toolbar - or right click before placing the part. Next we'll add the main component of the design - the ATmega328 microprocessor - as well as some components to support it. Step 4: Microprocessor and Supporting Circuitry Then left click again when it's where it needs to be. Left-click once on a part to pick it up (your mouse should be hovering over the part's red "+" origin). If you need to move parts around, use the MOVE tool - (left toolbar or under the Edit menu). Use the add tool for these parts:Īll of these parts will go in the top-left of the schematic frame. Next we'll add four different parts all devoted to our voltage supply input. How about " BareBonesArduino.sch" (SCH is the file format for all EAGLE schematics).Īs a bonus, after saving, your frame's title should update accordingly (you may have to move around the screen, or go to View > Redraw). Name your schematic something descriptive. To save either go to File > Save, or just click the blue floppy disk icon. Right now your schematic is an untitled temporary file living in your computer's ether. To get out of the add-mode either hit escape (ESC) twice or just select a different tool. After placing a part, the add tool will assume you want to add another - a new frame should start following your cursor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |